< For automobile >
 Cylinder Block Grinder, Cylinder Head Grinder, Cam Shaft Grinder
Home > Cylinder Block Grinder, Cylinder Head Grinder, Cam Shaft Grinder
|
Cast products have burrs on the sprue, gate, and mold mating parts, and
if these are not removed before the product is machined, the after-process
machining cannot be smoothly executed. Accordingly, various types of grinders
are used at the foundry to deburr mass-manufactured cylinder blocks, cylinder
heads, camshafts, and other engine parts. |
[NCG-SBC] |
|
| Features |
This grinder efficiently removes burrs and gate marks produced in automobile
cylinder blocks made of cast iron. Equipped with an automatic pallet phase
changeover function, this machine can grind 9 types of cylinder blocks
for 4 vehicle types. The cylinder block conveyed into the machine is ground
on two sides at the same time (the front and rear surfaces and the head
and oil pan surfaces) by means of two grinding units conveyed into the
machine. After grinding is completed, the cylinder block is carried out
by a loader. What is more, the grinding units have a grinding wheel wear
correcting function that corrects the grinding dimensions according to
the grinding wheel wear.
|
| Machine specification |
510xt125x
